Car Specifications and Safety
1. All competitors must use full size American made rear wheel drive passenger sedans. Station wagons OK.
2. All glass, chrome, trim etc must be removed. Dash and heater core must be removed.
3. Doors and trunk must be welded or chained shut with a minimum 3/8" chain
Hoods must be bolted or chained shut.
4. Gas tank must be removed and replaced with a six gallon or less fuel container mounted securelry in the back seatdriver's
side of the car. Fuel line must run out of the fuel tank through a hole in the floor pan directly adjacent to the tank and
under the car to the engine.
5. Two horizontal "spreader bars" will be mounted in the car. Bars will be a minimum 2 inches outside diameter and a
maximum 6 inches. Bars will be mounted 16 to 24 inches above floor pan. One bar will be installed behind the front seat to
the vertical "B" pilars. The other bar will be installed in the dash area in front of the driver.
6. Radiator must be mounted in stock position. Exhuast "zoomies" extended through the hood are optional.
7. Up to two batteries may be used, mounted securley in the passenger side front floor area. Batteries must be securley
covered with wood or rubber to prevent battery spilage contacting the driver.
8. Stock seat belt with shoulder harness is the minimum driver restraint required.
9. Drivers side door ONLY may be filled with concrete.
10. Bumpers must be welded or chained to cars frame with a minimum 3/8" chain Any gas charged cylinders in bumpers
must be relieved of pressure by drilling a hole in the cylinder.
11. Body mounts on full frame cars may be removed and body bolted directly to frame.
12. No electrical fuel pumps.
13. Drivers must wear helmets whenever in the car on the track. Helmets must accompany cars through safety and tech inspection.
14. Car number must be clearly visible on sides and roof.
15. Absolutely no reinforcement of car other than what is listed in these rules.
16. Hitting the driver's door is strictly prohibited and will result in disqualification.
